Thermador MD24JS Manuel d'installation télécharger pdf (Page 5)

English 3

Clearances and Dimensions

• For safety considerations do not install drawer in

any combustible cabinetry which is not in accord

with the stated clearances and dimensions in the

"MicroDrawer™ Microwave Oven Measurements"

section following. See Figure 3 (standard installation) or

Figure 4 (flush installation).

• Dimensions that are shown in Figure 3 (standard

installation) or Figure 4 (flush installation) must be used.

Given dimensions provide minimum clearance. Locate

electrical outlet in the shaded area in the upper left-hand

corner of the cutout. See Figure 6.

• Supporting surface must be solid and level. Pay special

attention to the floor of the cabinet opening on which

the MicroDrawer™ microwave oven will sit. The floor of

the opening should be constructed of plywood strong

enough to support the weight of the oven (about 100

pounds).

• Check the location where the MicroDrawer™ microwave

oven

will be installed for proper electrical supply.

• Your oven can be built into a cabinet or wall as a stand-

alone unit or under a built-in gas or electric wall oven.

• Check to be sure that there is a clearance of 2 inches

or greater between the top of the MicroDrawer™

microwave oven unit and the bottom of a built-in wall

oven above it.

• The microwave interior will easily accommodate a

9" x 13" oblong dish or a bag of microwave popcorn.

Unpacking Your MicroDrawer

™

Microwave Oven

• Remove all packing materials from inside the MicroDrawer™ micro-

wave oven. DO NOT REMOVE THE WAVEGUIDE COVER. The

Waveguide cover is a cardboard-like dark grey sheet about 9x10

inches that is attached to the MicroDrawer™ microwave oven ceiling.

• Check the drawer for any damage, such as misaligned or bent

drawer, damaged drawer seals and sealing surfaces, broken or

loose drawer guides and dents inside the cavity or on the front

side of the drawer. If there is any damage, do not operate the

MicroDrawer™ microwave oven and contact your dealer or a

THERMADOR

AUTHORIZED SERVICER.

Important Notes To The Installer

• Read and understand the contents of this Installation Manual before

installing the MicroDrawer™ microwave oven.

• Remove all packing material before connecting the electrical supply.

• It is the responsibility of the owner and the installer to assure compli-

ance with all applicable safety codes and standards. See UL 923,

The Microwave Cooking Appliances.

• The unit may be installed using a standard or flush (inset) installation

per the following instructions.

• Be sure to leave these instructions with the consumer.

Important Notes To The Consumer

Keep this manual with your Use and Care Guide for future reference.

• As when using any microwave oven generating heat, there are certain safety precautions you should follow. These are listed

in the Use and Care Guide. Read all and follow carefully.

• Be sure your MicroDrawer™ microwave oven is installed and grounded properly by a qualified installer or service technician.

WARNING

The appliance should only be installed by a licensed electrician or a qualified technician.

Waveguide

cover

Sealing

surface

Oven cavity

Sealing

surface

Figure 1

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Thermador MD24JS Manuel d'installation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes Thermador MD24JS